|
本实例综合性很强,基本上包含了Cisco交换机的所有交换技术 1. 网络拓扑和相应设计 目录: 网络配置实例 网络拓扑和相应设计 Catalyst 5509 配置 Catalyst 4003 配置 RSM 配置 Catalyst 5505 配置 网络拓扑和相关设计 网络拓扑图        2. Catalyst 5509 的配置 下面列出 Catalyst 5509 的基本配置 Enter password: Console> enable Enter password: Console> (enable) set system name 5509-ER-F1 System name set. 5509-ER-F1> (enable) set system location 1st Floor Equipment Room System location set. 5509-ER-F1> (enable) set system contact sysadmin@bigcorp.com System contact set. 5509-ER-F1> (enable) set time 04/30/1999 9:30:00 Fri Apr 30 1999, 09:30:00 5509-ER-F1> (enable) set password Enter old password: Enter new password: Retype new password: Password changed. 5509-ER-F1> (enable) set enablepass Enter old password: Enter new password: Retype new password: Password changed. 5509-ER-F1> (enable) set banner motd % 5509-ER-F1 (Catalyst 5509) Access Restricted % MOTD banner set 5509-ER-F1> (enable) set interface sc0 10.10.1.10/24 Interface sc0 IP address set. 5509-ER-F1> (enable) set ip route default 10.10.1.1 Route added. 5509-ER-F1> (enable) set ip dns server 10.10.10.100 10.10.10.100 added to DNS server table as primary server. 5509-ER-F1> (enable) set ip dns domain bigcorp.com Default DNS domain name set to bigcorp.com 5509-ER-F1> (enable) set ip dns enable DNS is enabled 5509-ER-F1> (enable) set vtp domain BigCorp mode server VTP domain BigCorp modified 5509-ER-F1> (enable) set vlan 10 name Corporate Vlan 10 configuration successful 5509-ER-F1> (enable) set vlan 20 name DevEng Vlan 20 configuration successful 5509-ER-F1> (enable) set vlan 30 name Mfg Vlan 30 configuration successful 5509-ER-F1> (enable) set vlan 40 name QA Vlan 40 configuration successful 5509-ER-F1> (enable) set vlan 50 name Finance&Admin Vlan 50 configuration successful 5509-ER-F1> (enable) set vlan 60 name Sales&Mktg Vlan 60 configuration successful 5509-ER-F1> (enable) set module name 1 Supervisor III Module name set. 5509-ER-F1> (enable) set port flowcontrol 1/1-2 send off Ports 1/1-2 flow control send administration status set to off (ports will not send flowcontrol to far end) 5509-ER-F1> (enable) set port flowcontrol 1/1-2 receive off Ports 1/1-2 flow control receive administration status set to off (ports will not allow far end to send flowcontrol) 5509-ER-F1> (enable) set port negotiation 1/1-2 enable Ports 1/1-2 negotiation enabled 5509-ER-F1> (enable) set port name 1/1-2 GEC 802.1Q Trunk Ports 1/1-2 name set. 5509-ER-F1> (enable) set port channel 1/1-2 desirable Port(s) 1/1-2 channel mode set to desirable. 5509-ER-F1> (enable) set trunk 1/1 desirable dot1q Port(s) 1/1 trunk mode set to desirable. Port(s) 1/1 trunk type set to dot1q. 5509-ER-F1> (enable) set module name 3 RSM (RSM-ER-F1) Module name set. 5509-ER-F1> (enable) set module name 5 Fast Ether Uplinks Module name set. 5509-ER-F1> (enable) set port name 5/1-4 FEC ISL Trunk Ports 5/1-4 name set. 5509-ER-F1> (enable) set port speed 5/1-4 100 Ports 5/1-4 transmission speed set to 100Mbps. 5509-ER-F1> (enable) set port duplex 5/1-4 full Ports 5/1-4 set to full-duplex. 5509-ER-F1> (enable) set port flowcontrol 5/1-4 send off Ports 5/1-4 flow control send administration status set to off (责任编辑：编程世界) |